H.265 VANGUARD 4x2H / 8x4H / 16x8H
159
5.4.1.4 PTZ
Please connect the PTZ cameras to the DVR and then configure the below PTZ settings. After
configuring the PTZ settings, you can start using the PTZ Control panel to control the
connected PTZ camera. Please refer to
5.2.3 PTZ Setting Panel
.
Channel:
Select a channel.
Protocol:
Select a communication protocol between the PTZ camera and DVR. If your camera
supports the UTC function,
select
COAX1
or
COAX2
. For more details on UTC function, please
refer to
3.4.2.3 UTC Control
.
Note:
EverFocus’ PTZ cameras can only connect to VANGUARD series DVRs through RS-
485. Therefore, EverFocus’ PTZ cameras does not support the UTC function.
Baudrate:
This field is to set the speed at which is used to transmit instruction or information
from the DVR to the PTZ camera.
Data Bit / Stop Bit:
The information between the DVR and PTZ camera is sent in individual
packages. The Data Bit indicates the number of bits sent, while the End Bit indicates the end of
the package and the beginning of the next (information) package.
Parity:
For error check. Refer to the documentation of your PTZ camera to configure this setting
Address:
Input the ID address of the PTZ camera. Note this address should match the one set up
on the PTZ camera.
Click
Save
to save the settings or
Refresh
to refresh the page.
Click the
Copy
button to display the channel options. Select the channels and then click the
Copy
button to copy the same configurations from this channel to the selected channels.
