EVCO S.p.A.
EVDRIVE04 | User manual ver. 1.1 | Code 144EPD4I114
Page 38 of 78
4.
Switch on the power supply of the device.
5.
Operate as related in the User manual of Parameters Manager.
7.6
Backup and restore
If the EVDRIVE04 driver version is displayed (using the built-in display or another display connected via the CAN port)
you can view the backup / restore pages which permit to save a copy of the memory areas of the parameters. The
copy can be done in another area of the memory or in an external memory (parameters key) connected to the
communication programming port.
It is possible to save both the application parameters (EVDRIVE04 parameters) and the driver parameters (calibration
network settings, ...).
It is possible to restore the parameters from copies in the memory (restore application or driver parameters) or load
the default parameters (load default configuration from flash memory).
The backup and restore functionalities are active only in Stand-by off (10).
7.6.1
Configuring the device through an USB flash drive
The following procedures show how to make the upload and the download of the configuration parameters through an
USB flash drive.
To copy the parameters from the device to the USB flash drive operate as follows:
1.
Make sure the power supply is switched on.
2.
Connect the flash drive to the device.
3.
With reference to step 28 of the paragraph 7.2 "Configuring a built-in version", from page 37 press button UP
or button DOWN to select “
key
” to copy the parameters in the flash drive or “
memory
” to copy the parameters
in the internal memory of the device, belonging to the field “
Application param.
” to copy the application
software parameters or belonging to the field “
Drivers param
”. to copy the configuration parameters.
4.
Press and release button ENTER: the parameters will be copied (this operation usually takes a few seconds; the
last line of the page provides information on the status of the process).
5.
Disconnect the flash drive.
To copy the parameters from the USB flash drive to the device operate as follows:
6.
Make sure the power supply is switched on.
7.
Connect the flash drive to the device.
8.
With reference to step 28 of the paragraph 7.2 "Configuring a built-in version", from page 38 press button UP
or button DOWN to select “
key
” to copy the parameters from the flash drive or “
memory
” to copy the
parameters from the internal memory of the device, belonging to the field “
Application param.
” to copy the
application software parameters or belonging to the field “
Drivers param
”. to copy the configuration
parameters.
9.
Press and release button ENTER: the parameters will be copied (this operation usually takes a few seconds; the
last line of the page provides information on the status of the process).
10.
Disconnect the programming flash drive.
The copy of the parameters from the flash drive to the device is allowed on condition that the
firmware of the devices coincides.
To quit the procedure operate as follows:
11.
Press and release button ESC over and over again: possible modifications will not be saved.
