EVCO S.p.A.
EVDRIVE04 | User manual ver. 1.1 | Code 144EPD4I114
Page 10 of 78
3.2
Installation
On DIN rail 35.0 x 7.5 mm (1.377 x 0.295 in) or 35.0 x 15.0 mm (1.377 x 0.590 in).
To install the device operate as shown in the following drawing.
1
2
To remove the device remove possible extractable screw terminal blocks plugged at the bottom first, then operate on
the DIN rail clips with a screwdriver as shown in the following drawing.
3
4
To install the device again press the DIN rail clips to the end first.
3.3
Additional information for the installation
-
make sure the working conditions of the device (operating temperature, operating humidity, etc.) are in the
limits indicated; look at chapter 11 “TECHNICAL DATA”
-
do not install the device close to heating sources (heaters, hot air ducts, etc.), devices having big magnetos
(big speakers, etc.), locations subject to direct sunlight, rain, humidity, dust, mechanical vibrations or bumps
-
according to the safety legislation, the protection against possible contacts with the electrical parts must be
ensured by a correct installation of the device; all the parts which ensure the protection must be fixed so that
you can not remove them if not by using a tool.
