Essilor Pro-E 600 edger, User Manual

Page: 50 / 198

a. Automatic grooving
Call up the desired shape located on the tracer or on the job management program.
The shape is displayed on the edger work screen.
After tracing a pattern, demo lens or re-cut lens, without any drilling settings:
• the groove finish is selected by default.
• the automatic mode is selected by default.
If you wish to produce a groove the depth and the width of which are less than 0.60 mm:
Directly define the groove in the screen.
Press and to regulate the depth and the width of the groove
Depth (mm) Width (mm)
By default 0.60 0.60
Minimum 0.20 0.60
Maximum 1.20 1.20
Select lens material.
Select the type of cycle.
Choose whether or not to polish and/or chamfer your lens.
For more information, consult the section Edging a lens > Perform a polishing
(
F
p.67)
and Edging a
lens > Perform a chamfering
(
F
p.67)
.
Press the “cycle start” button (front face) or .
The door closes, the lens is clamped and then felt.
The edging cycle starts.
When the edging cycle is finished, the retouch screen is displayed.
>
>
>
>
>
1
2
3
4
5
6
Pro-E 600_Pro-E 700 > v1 -10.18
50
U
SER
M
ANUAL
> II. E
DGING A LENS