Essilor Pro-E 600 edger, User Manual

Page: 28 / 198

B
EVEL
F
RAME
L
ENS
A
DVANTAGES
Classic Lens for which the front surface
base is approximately equal to the
frame base.
Makes it possible to do an aesthetically pleasing
job. The lens material does not protrude beyond
the front of the frame.
Classic Lenticular lens
&
, Executive lens
&
Makes it possible to do a job with specific lenses.
Classic Thin lens Makes it possible to balance out the bevel when
thin lenses are used.
Flat base
High base
Thin lens for which the front
surface base is approximately
equal to the frame base.
Makes it possible to retrieve the frame base in a
pattern tracing (base = 0).
Particular
groove
(groove with
meniscus
&
)
Thin lens for which the base is
approximately equal to the
meniscus of the groove.
Compliance with original shape.
Job using a specific frame.
Call up the desired shape located on the tracer or on the job management program.
The shape is displayed on the edger work screen.
After the tracing of a rimmed frame:
• The bevel finish is selected by default.
• The automatic mode is selected by default.
Select lens material.
Change the edging mode. Press to select customized mode .
Select the type of cycle.
Choose whether or not to polish and/or chamfer your lens.
For more information, consult the section Edging a lens > Perform a polishing
(
F
p.67)
and Edging a
lens > Perform a chamfering
(
F
p.67)
.
Press the “cycle start” button (front face) or .
The door closes, the lens is clamped and then felt.
The customized bevel finish screen is displayed.
>
>
>
>
1
2
3
4
5
6
Pro-E 600_Pro-E 700 > v1 -10.18
28
U
SER
M
ANUAL
> II. E
DGING A LENS