Configuring Port Mirroring
Setting Port Mirroring
Matrix NSA Series Configuration Guide
4-91
4.4.4.2
set port mirroring
Use this command to create a new mirroring relationship or to enable or disable an existing
mirroring relationship between two ports.
set port mirroring
{
create
|
disable
|
enable
} |
igmp-mcast
{
enable
|
disable
}
source
destination
[
both
|
rx
|
tx
]
Syntax Description
Command Defaults
If not specified,
both
received and transmitted frames will be mirrored.
Command Type
Switch command.
Command Mode
Read-Write.
create
|
disable
|
enable
Creates, disables or enables mirroring settings on the
specified ports.
igmp-mcast enable
|
disable
Enables or disables the mirroring of IGMP multicast
frames.
source
Specifies the source port designation. This is the port on
which the traffic will be monitored. For a description of
port types that can participate in mirroring, refer to
Section 4.4.1
. For a detailed description of possible
port-string
values, refer to
Section 4.1.1
.
destination
Specifies the target port designation. This is the port that
will duplicate or “mirror” all the traffic on the monitored
port. For a description of possible destination port
configurations supported on the Matrix Series device,
refer to
Section 4.4.3
. For a detailed description of
possible
port-string
values, refer to
Section 4.1.1
.
both
|
rx
|
tx
(Optional) Specifies that frames received and transmitted
by the source port, only frames received, or only frames
transmitted will be mirrored.