Matrix NSA Series Configuration Guide
13-1
13
Routing Protocol Configuration
This chapter describes the Routing Protocol Configuration set of commands and how to use them.
13.1 PROCESS OVERVIEW: ROUTING PROTOCOL CONFIGURATION
Use the following steps as a guide to configuring routing protocols on the device:
1.
Activating advanced routing features (
Section 13.2.1
)
2.
Configuring RIP (
Section 13.2.2
)
3.
Configuring OSPF (
Section 13.2.3
)
4.
Configuring DVMRP (
Section 13.2.4
)
5.
Configuring IRDP (
Section 13.2.5
)
6.
Configuring VRRP (
Section 13.2.6
)
ROUTER:
The commands covered in this chapter can be executed only when the
device is in router mode. For details on how to enable router configuration modes, refer
to
Section 2.3.3
.
NOTE:
The command prompts used in examples throughout this guide show a system
where module (or standalone device) 1 and VLAN 1 have been configured for routing.
The prompt changes depending on your current configuration mode, the specific
module, and the interface types and numbers configured for routing on your system.