Routing Protocol Configuration Command Set
Configuring VRRP
13-102
Matrix NSA Series Configuration Guide
13.2.6.9
preempt-delay
Use this command to set a preempt delay time on a VRRP router. When preempt mode is enabled
this specifies a delay (in seconds) that a higher priority backup router must wait to preempt a lower
priority master. For more information on setting preempt status, refer back to
Section 13.2.6.8
. For
more information on setting VRRP priority, refer back to
Section 13.2.6.4
.
preempt-delay vlan-id vrid delay-timer
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command clears the preempt delay timer:
no preempt-delay vlan-id vrid
Command Type
Router command.
Command Mode
Router configuration:
Matrix>Router1(config-router)#
Command Defaults
None.
NOTE:
The router that owns the virtual router IP address always preempts other
routers, regardless of this setting.
vlan vlan-id
Specifies the number of the VLAN on which to set a
preempt delay value. This VLAN must be configured for IP
routing as described in
Section 2.3.2
, and must have
preempt mode enabled as described in
Section 13.2.6.8
.
vrid
Specifies a unique Virtual Router ID (VRID) associated
with the routing interface.
Valid values are from
1
to
255
.
delay-timer
Specifies a preempt delay time in seconds. Valid values are
from
1
to
900
.