Routing Protocol Configuration Command Set
Configuring OSPF
13-42
Matrix NSA Series Configuration Guide
13.2.3.9
ip ospf hello-interval
Use this command to set the number of seconds a router must wait before sending a hello packet to
neighbor routers on an interface. Each Matrix Series routing module or standalone device can
support communications between up to 60 neighboring routers.
ip ospf hello-interval
seconds
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command sets the hello interval value to the default (10
seconds for broadcast and point-to-point networks, 30 seconds for non-broadcast
and point-to-multipoint networks):
no ip ospf hello-interval
Command Type
Router command.
Command Mode
Interface configuration:
Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to set the hello interval to 5 for VLAN 1:
seconds
Specifies the hello interval in seconds. Hello interval must
be the same on neighboring routers (on a specific subnet),
but can vary between subnets. This parameter is an unsigned
integer with valid values between
1
and
65535
.
Matrix>Router1(config)#
interface vlan 1
Matrix>Router1(config-if(Vlan 1))#
ip ospf hello-interval 5