Security Configuration Command Set
Configuring Policy-Based Routing
Matrix NSA Series Configuration Guide
14-181
14.3.13.8 ip policy load-policy
Use this command to configure PBR next hop behavior. When more than one next hop is configured
(using the
set next hop
command as described in
Section 14.3.13.4
) the load policy specifies
choosing one next hop from among the sequence of next hops in the map matching the current
packet. A next hop is considered available by default unless a pinger task is running and has flagged
it as unavailable.
ip policy load-policy
{[
first-available
] [
round-robin]
[
ip-hash
{
sip
|
dip
|
both
}]}
Syntax Description
Command Syntax of the “no” Form
The “no” form of this
command resets the next hop behavior to
first-available
:
no ip policy
load-policy
Command Type
Router command.
Command Mode
Interface configuration:
Matrix>Router1(config-if(Vlan <vlan_id>))#
Command Defaults
If
pinger
is not specified, none is configured.
Example
This example shows how to set the load policy behavior on VLAN 1 to “round-robin”:
first-available
|
round-robin
|
ip-hash
sip
|
dip
|
both
Specifies next hop selection behavior as:
•
first-available
(default) - uses the first available next
hop from the list of next hops
•
round-robin -
circulates among the available next hops
in the list.
•
ip-hash sip
|
dip
|
both
- chooses a next hop based on a
XOR hash of the IP source address, the IP destination
address, or both.
Matrix>Router1(config)#
interface vlan 1
Matrix>Router1(config-if(Vlan 1))#
ip policy load-policy round-robin