Enterasys Matrix 2G4072-52, Configuration Manual, Page: 496 / 1422

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6-44 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.1.31 set spantree hello
Use this command to set the device’s Spanning Tree hello time, This is the time interval (in seconds)
the device will transmit BPDUs indicating it is active.
set spantree hello interval
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to globally set the Spanning Tree hello time to 10 seconds:
interval Specifies the number of seconds the system waits before
broadcasting a bridge hello message (a multicast message
indicating that the system is active). Valid values are
1 - 10 .
Matrix(rw)-> set spantree hello 10