Security Configuration Command Set
Configuring Convergence End Points (CEP) Phone Detection
14-116
Matrix DFE-Platinum and Diamond Series Configuration Guide
14.3.8.14 clear cep
Use this command to clear convergence end points parameters.
clear cep
{
all
|
policy
|
detection
[
detection-id
] |
users
[
port-string
] |
port
[port-string
{
all
|
cisco
|
h323
|
siemens |sip
} ] }
Syntax Description
Command Defaults
If no
detection-id
is specified, all CEP detection groups are returned to the default
configuration.
If no
port-string
is specified with the
users
parameter, all discovered Convergence
Endpoints are cleared.
If no
port-string
is specified with the port parameter, all ports are cleared.
Command Type
Switch command.
Command Mode
Read-Write.
all
Restores factory defaults to all CEP configuration
information.
policy
Restore
factory
defaults
to CEP policy configuration.
detection
[detection-id
]
Restore factory defaults to CEP detection group
configuration. Optionally, specify a particular CEP
configuration group to clear with
detection-id
. Valid values
are
1
-
2147483647
.
users [port-string
] Clear discovered Convergence Endpoints. Optionally,
specify one or more port(s) on which to clear discovered
CEPs. For a detailed description of possible
port-string
values, refer to
Section 4.1.1
.
port
[
port-string
{
all | cisco
|
h323
|
siemens | sip
}]
Resets the CEP enabled state to the default of disabled.
Optionally, specify one or more port(s) to disable and
specify all detection types or individual detection types to
disable. For a detailed description of possible
port-string
values, refer to
Section 4.1.1
.