SNMP Configuration Command Set
Configuring SNMP Access Rights
5-30
Matrix DFE-Platinum and Diamond Series Configuration Guide
5.3.3.2
set snmp access
Use this command to set an SNMP access configuration.
set snmp access
groupname
security-model
{
v1
|
v2c
|
usm
} [
noauthentication
|
authentication
|
privacy
] [
context
context
] [
exact
|
prefix
] [
read
read
] [
write
write
] [
notify
notify
] [
volatile
|
nonvolatile
]
Syntax Description
groupname
Specifies a name for an SNMPv3 group.
security-model v1 |
v2c | usm
Specifies SNMP version 1, 2c or 3 (usm).
noauthentication |
authentication |
privacy
(Optional) Applies SNMP security level as no
authentication, authentication (without privacy) or
privacy. Privacy specifies that messages sent on behalf of
the user are protected from disclosure.
context
context
exact
|
prefix
(Optional) Sets the context for this access configuration
and specifies that the match must be exact (matching the
whole context string) or a prefix match only. Context is a
subset of management information this SNMP group will
be allowed to access. Valid values are full or partial
context names. To review all contexts configured for the
device, use the
show snmp context
command as
described in
Section 5.3.4.2
.
NOTE:
A routing module must be specified as
a
context
to allow for SNMP management when
operating in router mode.
read
read
(Optional) Specifies a read access view.
write
write
(Optional) Specifies a write access view.
notify
notify
(Optional) Specifies a notify access view.
volatile |
nonvolatile |
read-only
(Optional) Stores associated SNMP entries as temporary
or permanent, or read-only.