160
Control Message Description
The Control Message is a read/write message containing fields to start and stop the compressor, change the
compressor mode, and change the control setpoint group number.
The contents of the Control Message are shown in the following table and described further in the paragraphs
below.
NOTE
:
The Control Message may not be written unless the Allow Network Control selection is set to Yes.
Commands other than Network In Control can only be written once the Network In Control
Command has been issued.
NOTE
:
The data described by each register may be slightly different depending on if the register is being read or written.
Summary of Contents for Vilter VilTech
