
26
Field Types
This section discusses the procedures used to work with each of the
F
IELD
T
YPES
as well as the general
procedures that apply to all number entry fields. The following information applies to any field when entering
numerical data:
Decimal Number Entry
-If the data you wish to enter has a zero in the decimal place there is no need to enter “0.”
Simply enter the whole number value.
Arrow Keys
- The arrow keys will accept the entered data and move the cursor to the next field.
Errors
- The flashing error message tells the user that the entered data is not within an acceptable range for the
field. The user must clear the error before proceeding. To clear an error message the operator presses the CLEAR
key.
Restoring Valid Data
-The user can clear and re-enter data from any field prior to leaving the field. If the arrow key
or the
ENTER
key is used to move off the field after it has been cleared, the previously entered valid data will be
restored to the field.
Selectable Fields
A
S
ELECTABLE
F
IELD
gives the user a choice of inputs from which to toggle
through and is recognized by the “>” cursor preceding it.
1. Verify Cursor Type
- locate the “>” selection cursor.
2. ENTER Key
- cycles the user through the available selections.
3. Arrow Keys
- move to the next field and accept the selection.
Numerical Data Input Fields
A numerical field is used to enter control data and is recognized by the “*”
cursor preceding it.
1. Verify Cursor Type
- locate the “*” numeric input cursor.
2. Number Keypad
- press the number keys that correspond to the number you wish displayed. Use the
decimal and minus keys where applicable. Each field will limit the user to a maximum number of whole and
decimal numbers for that specific field.
3. ENTER/Arrow Keys
-move to the next field and accept the entered number.
4. Verify Cursor Type
- Upon pressing the
ENTER
or DOWN ARROW key, if the cursor moves across to
the units column and changes to the “>” selectable cursor, the user is in a suction pressure field which is
described in the next section.
Summary of Contents for Vilter VilTech
