Emerson Tescom ER5000 Series, User Manual, Page: 120 / 248

ER5000 —
120
The ERTune™ Program: Basic Features
If this is the first time the ER5000 has been connected to the
computer, you will be taken through the steps to set up the
ERTune™ program for your controller and application. The
program runs the setup sequence every time it communicates
with an ER5000 that has a new serial number.
To set up the ERTune™ program to work with the ER5000
NOTE NOTE
CAUTION CAUTION
WARNING WARNING
Be sure you have the following information in hand:
• The model number of your ER5000, which is located on the
label on the side of the controller.
• If you are using a TESCOM™ regulator, the series number,
model number and serial number of the regulator you are
using.
• The range of your external feedback transducer.
1. Click the
Next >
button. The Node and Model window opens.
2. The Node Address is set to a default of 250. If you are using
multiple controllers in a daisychain on the same network,
you must assign each controller a unique Node Address
during this step. If you are using a single controller, there is
no need to change the default value.
NOTE NOTE
CAUTION CAUTION
WARNING WARNING
The maximum value for the Node Address is the default
of 250. If you assign a different Node Address, use a number that
is less than 250. Numbers larger than 250 will be truncated to the
first two digits.
(continued next page)