Emerson Rosemount CT5800, Manual

Page: 109 / 192

WARNING
BURNS
Some parts of the analyzer may be heated to 150 °F (65 °C). Failure to allow sufficient
cooling may cause serious burn injury to personnel.
Do not touch any part of the analyzer.
Assume all parts of the analyzer are hot unless it has been switched off and allowed to
cool down.
Always wear proper protective equipment when handling the analyzer.
Switch off the analyzer and allow it to cool for at least two hours before fitting,
removing, or performing any maintenance.
The analysis cell is insulated against heat loss. Allow the analyzer to cool for at least 12
hours before performing any maintenance on, or in the vicinity of, the analysis cell.
If burns occur, seek immediate medical treatment.
WARNING
HEAVY ITEM
The analyzer weighs 176.4 lb. (80 kg). Failure to properly handle the analyzer may cause
injury to personnel.
Use a minimum of two people when lifting and transporting the equipment.
Wear suitable protective gloves and protective footwear.
NOTICE
As a general principle, if any optical component other than the cell assembly and the laser
modules is unserviceable, then the manufacturer must repair the analyzer. This is because
the repair, replacement, and alignment of the optical components requires the use of
special optical test/calibration equipment and procedures.
7.8 Tools required for troubleshooting
The following tools are required to remove and replace components
Table 7-1: Required Tools
14 mm Hex key needed to open the box
2.5 mm Hex Socket (Allan key)
4.0 mm Hex Socket (Allan key)
5.0 mm Hex Socket (Allan key)
7.0 mm Spanner
8.0 mm Spanner
14 mm Spanner
16 mm Spanner
Reference Manual Troubleshooting and diagnostics
00809-0100-5800 September 2019
Rosemount CT5800 109