![background image](http://html.mh-extra.com/html/emerson/pm8560/pm8560_user-manual_101424033.webp)
Setup:
Troubleshooting
10006609-03
Pm8560
User’s Manual
2-9
2
From the back of the baseboard, insert and tighten the two screws in the standoffs closest
to the PMC connectors (see
Fig. 2-4
).
3
Insert and tighten the two remaining screws near the front panel.
Figure 2-6:
Installing the Pm8560 on the Baseboard
TROUBLESHOOTING
In case of difficulty, use this checklist:
❐
Be sure the Pm8560 circuit board is seated firmly on the baseboard and the baseboard is
seated in the carrier.
❐
Be sure the system is not overheating.
❐
Check the cables and connectors to be certain they are secure.
❐
Check your power supply for proper DC voltages. If possible, use an oscilloscope to look
for excessive power supply ripple or noise (over 50 mV
pp
below 10 MHz).
❐
Check that your terminal is connected to a console port.
1
Se
ria
l
Re
set
10/1
00
L N
K
A C
T
Tighten these two screws first.
Summary of Contents for Pm8560
