Emerson Machinery Health Expert CSI 2600, User Manual

Page: 68 / 110

3. Click the Tach drop-down menu and select the tachometer to be used for
acquisition.
This will be a tachometer connected to CSI 2600 tach location 1, 2, 3, or 4.
The Tach Clause dialog opens.
4. Click the Comparison drop-down menu and select an equation for the predicate.
5. Enter an RPM value in the Speed1 field.
6. Click
OK
.
7. Click
Apply
to finish.
6.3.4 Configure a database for transient operation
The CSI 2600 system may be used to simultaneously monitor machinery under normal
operating conditions and to create a large archive of information for those signals
designated (while building the database) as transient. All sensor connections to the CSI
2600 are configured for predictive operation. Some (or all) of these are also designated as
transient and are configured for transient operation.
Procedure
1. Create collection predicate for transient auto-archive operation.
When you create an auto-archive definition, this collection predicate will cause the
CSI 2600 to automatically transfer an archive of transient measurements to the
online server, where they can be viewed by an analyst. Archives stored on the
transient hard drive will eventually be written over by new measurements.
2. Configure the Measurement Points to associate tach channels with vibration
channels.
a. In Online Configuration, right-click Areas , select Add Area .
b. Enter an Abbreviation and Description , and click Apply .
c. Right-click the newly created Area and select
Add Equipment
.
d. Enter an Abbreviation and Description , and click Apply .
e. Right-click the newly created Equipment and select Add Component .
f. Enter an Abbreviation and Description , and click Apply .
g. Right-click the newly created Component and select
Add Measurement Pt
.
h. Enter an Abbreviation and Description , and click Apply .
i. With Component Properties still open, click the Monitoring Unit tab.
Data collection and analysis
64 MHM-97453, Rev 1