An analyst must know the sensitivity and offset of signals connected to the CSI 2600,
which may be the same (or different) as signals connected to existing modules. An analyst
must also know if the CSI 2600 connections are to buffered or unbuffered field wiring or
module outputs.
3.10
Access the termination board
1.
At the bottom of the rear panel, loosen the thumbscrews by hand.
WARNING!
Close the rear panel before powering the CSI 2600.
2.
To lock the rear panel in the open position, lift the panel to an almost horizontal
position and gently push down near the top center of the panel (as shown).
Termination board
Figure 3-5:
3.
Toggle the DIP switch to the left to turn off sensor power, or to the right to turn it
on.
The set of four DIP switches on SW1 controls sensor power for channels 1–4. Sensor
power for the subsequent channels is controlled by the DIP switches on SW2, SW3,
SW5, SW6, and SW7.
Getting started
18
MHM-97453, Rev 1
Summary of Contents for Machinery Health Expert CSI 2600
