Embraer EMB-505 Phenom, Service Manual

Page: 77 / 224

GROUND HANDLING AND
SERVICING HANDBOOK
EFFECTIVITY: ALL 12-11-00-680-801-A/300
Page 301
NOV 20/09
Copyright © by EMBRAER S.A - All rights reserved - See title page for details.
H
A
R
D
C
O
P
Y
I
S
U
N
C
O
N
TR
O
L
L
E
D
.
O
N
C
E
P
R
IN
TE
D
,
T
H
IS
P
A
G
E
M
U
S
T
N
O
T
B
E
R
E
T
A
IN
E
D
FO
R
F
U
TU
R
E
R
E
F
E
R
E
N
C
E
.
B
E
FO
R
E
U
S
IN
G
,
M
A
K
E
S
U
R
E
TH
IS
H
A
R
D
C
O
P
Y
I
S
T
H
E
L
A
TE
S
T
IS
S
U
E
.
GHSH TASK 12-11-00-680-801-A
1. Fuel Tank - Draining
A. General
(1) This task gives the procedure to drain the fuel from the fuel tanks.
(2) Examine the fuel drained from each tank for water and other contami-
nants. You will usually see water as a layer below the fuel or as small bub-
bles in the fuel.
(3) Let the aircraft be stable for approximately 2h (hours) before you drain it.
B. Job Set-Up
(1) Do the procedure to make the aircraft safe for maintenance (GHSH TASK
20-00-00-910-801-A/200).
(2) Do the procedure to make the aircraft safe for maintenance of the fuel sys-
tem (GHSH TASK 28-00-00-910-801-A/200).
(3) Statically ground the aircraft (GHSH TASK 20-40-02-910-801-A/200).
NOTE : Make all grounding connections between the fuel source, air-
craft, and fuel nozzle (refer to the requirements of the local
regulatory authorities).
WARNING: USE AN EXPLOSION-PROOF HEAT GUN IN AREAS
WHERE THERE IS RISK OF EXPLOSION. ADJUST THE
TEMPERATURE OF THE HEAT GUN TO A VALUE LESS
THAN THE FUEL SELF-IGNITION TEMPERATURE IN THE
AIRCRAFT FUEL TANK. IF YOU DO NOT OBEY THIS
PRECAUTION, AN EXPLOSION CAN OCCUR AND
CAUSE INJURY TO PERSONS AND DAMAGE TO
EQUIPMENT.
CAUTION : THE HOT AIR TEMPERATURE FROM THE HEATING GUN
MUST NOT BE MORE THAN 50 °C. TEMPERATURES
ABOVE 50 °C CAN CAUSE DAMAGE TO THE AIRCRAFT
SYSTEMS.
(4) For cold weather conditions, do a check of the fuel temperature as follows:
NOTE : When the tank temperature is less than 0 °C (32 °F), you must
not directly operate the drain valve. At a temperature less than
0 °C (32 °F), water can freeze around the drain valve and make
the water flow impossible. If applicable, before you operate the
drain valve to drain the wing tank, use a heat gun to apply heat
to the drain valve area.
• Energize the aircraft with an external DC (Direct Current) power supply
(GHSH TASK 24-41-00-860-801-A/200).
• Do a check of the fuel temperature on the synoptic page.