29/112
WL31/WL31TG
6. The control panel, after recognizing the information and acquiring the device, makes a series of acoustic
signals (“beeps”) and the display shows the message «HPnn Acquisition - Siren est.», where nn indicates
the address given to the device.
Advice n. 1
: take note of this address and write it on an adhesive label to place on the back of the siren
(this will be useful during the configuration phase). Note down the same address on the programming
tables situated at the end of this manual.
Advice n. 2
: if the control panel does not acquire the device, carry out its reset according to the
instructions contained in the DEVICE RESET paragraph.
7. The siren flashing remains on to confirm that it has been acquired. This signal is useful to remember which
devices have already been acquired. The method to switch the flashing off will be explained later.
4.1.5 KP30WL KEYBOARD
1. Open the keyboard by slightly rotating the flap situated on the lower side with a screw driver.
2. Insert the supplied battery according to the correct pole positions.
3. All the LEDs turn on for about 5 seconds and then the green LED slowly flashes (see figure) to indicate the
“unprogrammed status”.
4. Press the key number 2 to acquire the keyboard. The green LED flashes quickly to show that the information is
being transmitted to the control panel.
5. The control panel and the KP30WL keyboard internal buzzer, after acquiring the device, make a series of
acoustic signals (“beeps”). The display shows the message «KPnn Acquisition - Keyboard», where nn indicates
the address given to the keyboard.
Advice n. 1
: take note of this address and write it on an adhesive label to place on the back of the
keyboard (this will be useful during the configuration phase). Note down the same address on the
programming tables situated at the end of this manual.
Advice n. 2
: if the control panel does not acquire the device, carry out its reset according to the
instructions contained in the DEVICE RESET paragraph.
6. The keyboard flashing remains on to confirm that it has been acquired. This signal is useful to remember which
devices have already been acquired. The method to switch the flashing off will be explained later.
