(((ELKRON))) - MP110
PROCEDURE ACCESS
COD.
UT.1/3
EXIT
F
8
4.6
Clock - LCD Keypad
4.6.1 Date/time visualization
•
Press key
C
**
followed by key
8
.
•
The display shows date and time: “dd-mm-yy hh-mm” replacing the
message “((EKLRON) MP 110)”.
•
To re-establish the factory set message replacing the time, press
sequence
C
**
+
0
.
4.6.2 Hour/minute modification
1. Enter Master or Engineer code
2. Press
F
and
8
in sequence
3. The display will show: “Prog. Time hh:mm”
4. Enter a value from 00 to 23 (2 digits required) for hours
5. Enter a value from 00 to 59 (2 digits required) for minutes
•
To confirm and store the entered time, press key
F
.
•
Before recording the entered time, the entered data are controlled. In
case of inconsistency, an error beep is generated and you go back to
point 3. In case of correct data, the new time is recorded and the positive
operation is confirmed with an OK beep. When quitting by timeout, the
modification is not saved.
4.6.3 Date visualisation
1. Enter MASTER or ENGINEER code
2. Press
F
and
5
in sequence
3. The display will show: PRG DATE dd-mm-yy
4.5.1 Recognition of Key with Masked System (see par 5.10)
•
When the system is masked, all the commutator leds are OFF.In this way it is impossible to know whether the
system is armed and masked or actually turned OFF.
•
The insertion of a key with valid code causes all four commutator leds to light up for 0.5s. This indicates that the
key code has been correctly readand is followed by the display of system mode for 3.5 seconds.
•
Removal of the key before this time has expired causes the system to return to the masked mode; leaving the
key inserted enables a change in system mode like the one that took place with the arming/disarming procedure
by electronic key.
•
With the masked system, all the keypad leds are OFF. In this condition, it is impossible to know whether the
system is masked or it is actually OFF. By typing a valid code on the keypad with which one is working, the
system status is displayed for 1 minute.
PROCEDURE ACCESS
COD.
UT.1/3
EXIT
F
5
44
