© ElektroPhysik
MiniTest 725, MiniTest 735, MiniTest 745
10 / 85
Total Reset
Press OK to confirm.
IrDA- Port
(cont. active)
Press OK to confirm “cont. active”
Power supply
(Battery)
Press OK to confirm.
For more detailed information on the initialising sequence please refer to section 10.1.
The Start screen appears showing gauge model and sensor type being
connected (see fig. on the left)
With the FN sensors, the measuring method can be selected:
-
Press arrow up key for “Ferrous” (F for magnetic induction method)
-
Press arrow down key for “Non-ferrous” (N = eddy currents method).
-
Press OK to confirm your selection.
If you make no selection at all, the Auto F/N method will be automatically
adjusted after 5 seconds (see fig. on the left).
a) Now the gauge is in the measure mode and ready for measurement. The measure screen
appears (see fig. below). Readings are not yet available.
b) At initial use, “Batch 00” (see section 7.2.2) and the factory pre-setting (“STD”) are active.
For further information on “Calibration”, please refer to section 6. The active batch and the
calibration mode are shown in the status line.
c) The factory pre-setting is recommended for quick and easy measurement and if a medium
measuring accuracy is sufficient. For more details on calibration methods please refer to
section 6.2.
d) To take readings, place the sensor in right angle onto the measuring object. The coating
thickness will be immediately displayed on the screen. Remove sensor and take next
reading.
Status line
Set calibration
method
Active
Batch
Battery
state
Active measuring proce-
dure, here: Auto F/N
Time
Online statistics
Bluetooth active