
3. Installation
3.1 Prerequisites for the location of use
3.1 Prerequisites for the location of use
The RTD must be used as intended and exclusively in locations for which the RTD
has been approved/certified.
A 24 VDC power supply (-20%/+25%) must be ensured as per the specifications.
RTD units are intended to be flush mounted in control cabinets, control panels, or
control consoles.
l
If the Ethernet connection is routed out of the building at one point, a network isol-
ator (switch, for example) must be used without fail.
l
The devices can only be installed in landscape mode. Please make sure that the
TOP
top side is on top
√
TOP
l
Do not use the RTD in hazardous locations.
See also
→ " Use as intended", page 17
Label on the → "Nameplate", page 22
The specifications in → "The environmental ambient conditions for operation
must not exceed the specified values:", page 38.
36
easyE Remote Touch Display
01/24 MN048027EN Eaton.com
Summary of Contents for easyE
