Eaton easyE, Manual, Page: 32 / 111

2. Safety regulations
2.3 Device-specific hazards
CAUTION
NON-GALVANICALLY-ISOLATED INTERFACES
The RTD may be damaged by potential differences.
Do not connect the connector to the RTD or disconnect it
without first de-energizing the system.
CAUTION
SHORT-CIRCUIT HAZARD
If the Resistive Touch Display is or has been exposed to envi-
ronmental fluctuations (ambient temperature, air humidity), con-
densation may form on or inside RTD. As long as this condensation is
present, there will be a short-circuit hazard.
Do not switch on the device when it has condensation in or on it.
If the Resistive Touch Display has condensation in or on it, or if it has
been exposed to environmental fluctuations, let the RTD settle into
the existing ambient temperature before switching it on. Do not
expose the device to direct thermal radiation from heating app-
liances.
CAUTION
UV LIGHT
Plastics will become brittle when exposed to UV light. This artificial
aging will reduce the RTD unit's lifespan.
Protect the Resistive Touch Display unit from direct sunlight and
other sources of UV radiation.
CAUTION
POINTY, SHARP OBJECTS AND CORROSIVE LIQUIDS
When cleaning the Resistive Touch Display:
l
Do not use any pointy or sharp objects (e.g., knives).
l
Do not use aggressive or abrasive cleaning products or solvents.
Make sure that no liquids get into the device (short-circuit hazard)
and that the RTD is not damaged in any way.
CAUTION
INSTALLATION CUT-OUT
The mounting cutout must be located in a position that will not defeat
the purpose of stabilizing webs or other reinforcing elements in the
control panel. If necessary, reinforcing elements must be instal-
led/added.
An IP65 degree of protection will only be ensured if there is sufficient
32
easyE Remote Touch Display 01/24 MN048027EN Eaton.com