2-47
D Y N O I N S T A L L A T I O N
Load Cell Calibration
Version 4
Above Ground Model 250i Motorcycle Dynamometer Installation Guide
11 Install the calibration arm and weights using the bolts at the end of the calibration
arm.
Note:
If you do not have enough room to use the bolt pattern closest to the end of
the calibration arm, use the bolt pattern in the center of the arm. Refer to Figure
2-45.
11a Secure the calibration arm to the eddy current brake by tightening the bolt
using the handle.
11b Gently place the weights on the calibration arm.
Note:
Verify the calibration arm is not contacting the cover.
The calibration weights are very heavy. The weights must be set on the
arm gently or you could damage the load cell.
Figure 2-44: Install the Calibration Arm and Weights Using the Bolt Pattern Closest to the End
T 074
M
weights
weight support pin
secure arm to brake by
tightening handle
