2-15
D Y N O I N S T A L L A T I O N
Eddy Current Brake Installation
Version 4
Above Ground Model 250i Motorcycle Dynamometer Installation Guide
EDDY CURRENT BRAKE INSTALLATION
The eddy current brake is an optional accessory. This section will walk you through
removing the eddy current brake from the crate, and attaching the brake to your dyno.
If you did not purchase the eddy current brake, skip this section and continue with
“Secure the Dyno and Brake Module to the Floor” on page 2-25.
You will need to provide equipment capable of lifting the eddy current brake off the
crate and into position in your dyno room. You will also need a pair of straps. Dynojet
recommends using continuous nylon loop style straps.
Refer to
for information on the power requirements for the eddy current
brake.
To prevent possible injury, verify all power cords are unplugged.
U
NPACKING
THE
E
DDY
C
URRENT
B
RAKE
1
Remove the top and sides of the crate.
2
Remove any hardware and parts boxes from the crate and verify the box contents.
Figure 2-11: Remove the Crate Top
remove boxes
