2-3
D Y N O I N S T A L L A T I O N
Unpacking and Inspecting the Dyno
Version 4
Above Ground Model 250i Motorcycle Dynamometer Installation Guide
5
Remove the six 1/4-inch screws securing the center panel on the dyno and remove
the center panel.
Note:
Dynojet recommends using a T30 Torx driver (Snap-On PFTx30E) to
remove the 1/4-inch screws.
6
Remove the tire stop, tire lock, and hardware from the middle of the dyno.
Figure 2-2: Remove the Center Panel
D 037
C
center panel
tire stop and tire lock
in middle
