C H A P T E R 3
Power Carriage
Above Ground Model 250i Motorcycle Dynamometer Installation Guide
3-36
R
EMOVING
THE
H
AND
W
HEEL
To prevent possible injury, open the CPI door and set the main breaker to
the off position and unplug the dyno. Refer to “Main Dyno Power” on page
3-2 for breaker location.
1
Loosen the set screw on the hand wheel and remove the hand wheel.
2
Using a 7/16-inch wrench, remove the two bolts securing the flange bearing.
Figure 3-36: Remove the Hand Wheel
bolt
flange bearing
hand wheel
