C H A P T E R 2
Cable Routing
Above Ground Model 250i Motorcycle Dynamometer Installation Guide
2-36
R
OUTING
THE
P
OWER
C
ARRIAGE
AND
W
HEEL
C
LAMP
C
ABLES
The power carriage and wheel clamp are optional accessories. These cables will only
be used if you ordered the accessories.
For installation instructions refer to “Power Carriage” on page 3-35 and “Wheel
Clamp” on page 3-39 for more information.
1
Remove the two screws securing the cable pass through cover on the front of the
dyno and set aside.
2
Locate the cables bundled inside the dyno.
3
Route the power carriage and wheel clamp cables through the opening in the front
of the dyno.
Figure 2-32: Remove the Cable Pass Through Cover
route cables
through
cable pass through
cover
