4-11
C O N T R O L P A N E L I N T E R F A C E O P E R A T I O N
Maintenance and Troubleshooting
Version 4
Above Ground Model 250i Motorcycle Dynamometer Installation Guide
R
EPLACING
THE
E
DDY
C
URRENT
B
RAKE
D
RIVER
F
USES
The eddy current brake driver has two fuses. For more information on routing the
controller cable refer to“Cable Routing” on page 2-28.
Hazardous voltage. To prevent possible injury, open the CPI door and set
the main breaker to the off position and unplug the dyno. Refer to “Main
Dyno Power” on page 3-2 for breaker location.
1
Open the Control Panel Interface (CPI) cover and set aside.
2
Gently push the fuse holder slightly inward and rotate counterclockwise. Remove
the fuse holder.
3
Replace the fuse with a fuse type listed below.
For continued protection against risk of fire, replace only with a fuse of
the same type and having the same electrical rating.
• 20A, Bussman BAF-20
• Fast Blow, Dynojet P/N 54200014
Figure 4-3: Replace Eddy Current Brake Driver Fuses
MC153
fuses
