C H A P T E R 3
Air Brake
Above Ground Model 250i Motorcycle Dynamometer Installation Guide
3-10
C
HANGING
THE
B
RAKE
P
ADS
To prevent possible injury, open the CPI door and set the main breaker to
the off position and unplug the dyno. Refer to “Main Dyno Power” on page
3-2 for breaker location.
1
Remove the top and right side covers from the dyno. Refer to page 2-4 and
page 2-5 for more information.
2
For safety, apply the brake and disconnect the air supply at the front of the dyno.
Refer to Figure 3-3 on page 3-4.
3
Remove the hairpin cotter and loosen the castle nut until the pads clear the rotor.
Figure 3-11: Loosen the Castle Nut
remove hairpin cotter
adjust castle nut
outboard brake pad
