1-5
S P E C I F I C A T I O N S A N D O P E R A T I N G R E Q U I R E M E N T S
Dynamometer Specifications and Requirements
Version 4
Above Ground Model 250i Motorcycle Dynamometer Installation Guide
DYNAMOMETER SPECIFICATIONS AND REQUIREMENTS
The following specifications and requirements will help you set up your dyno area and
verify you have the requirements necessary to operate your dyno safely. For more
information about dyno room setup and layout, refer to the Pre-Installation
Guide P/N 98200081.
B
ATTERY
R
EQUIREMENTS
Your 200i/250i dyno is designed to carry a group 24 deep-cycle discharge series
battery for operating the starter, power carriage, and optional wheel clamp. The
typical dimensions for this series of batteries are 27 cm long by 17 cm wide by 23 cm
tall (10.625-inches by 6.75-inches by 9.125-inches). The mounting is flexible so a
battery that has dimensions close to this will work satisfactorily. The built-in battery
cables are configured for top-post batteries. This battery is not included with your
dyno. You will need to provide this battery. For more information on installing the
battery, refer to “Installing the Battery” on page 2-10.
C
HASSIS
S
PECIFICATIONS
description
specifications
Length
with standard carriage
allow 272.00 cm (107.00 inches)
with extended carriage
allow 323.00 cm (127.00 inches)
Height
to top of dyno cover
47.00 cm (18.50 inches)
Width
model 200i
107.00 cm (42.00 inches)
model 250i
180.00 cm (71.00 inches)
Weight
model 200i dyno/crated dyno
725 kg (1,600 pounds)/771 kg (1,700 pounds)
model 250i dyno/crated dyno
1,077.28 kg (2,375 pounds)/1,133.98 kg (2,500 pounds)
Drum
diameter
45.72 cm (18.00 inches)
width
50.80 cm (20.00 inches)
Frame
structural steel channel and angle
Maximum Speed
322 KPH (200 MPH)
Maximum Motorcycle Length (front of
front wheel to center of rear wheel)
standard carriage
213.00 cm (84.00 inches)
extended carriage
256.00 cm (101.00 inches)
Remote Switches
remote software control
