A P P E N D I X C
EEC Finger Guards Installation
Above Ground Model 250i Motorcycle Dynamometer Installation Guide
C-4
I
NSTALLING
THE
EEC F
INGER
G
UARDS
1
Secure each EEC finger guard to the drum module hood using two
1/4-20 x 5/8-inch pan-head torx screws.
Figure C-2: Secure the EEC Finger Guards to the Drum Module Hood
2
Secure the drum module hood with the EEC finger guards to the dyno using the
eight 1/4-20 x 5/8-inch pan-head torx screws removed earlier.
Do not operate the dynamometer without the EEC finger guards properly
installed. The gap between the finger guards and the drum must be less
than 0.64 centimeters (0.25 inches). Refer to page C-5 for instructions on
adjusting the gap.
drum module hood
screw
finger guard
