116 | Dome CXtra
To set up entries on the Photometers tab
1 Select a photometer from the pull-down list. Select Other if your
photometer is omitted from the list.
NOTE: All photometers must adhere to section 7.1 of the DIN
specification. When you select Other, you must manually enter
the measured values in the test wizard dialogs.
2 If you selected Other in step 1, type the name of the photometer
manufacturer in the Manufacturer field.
3 Enter the photometer serial number in the Serial Number field.
4 On the COM Port pull-down list, select the COM port used to
connect the photometer to the computer.
5 Click Apply.
If you selected Other in step 1, a message reminds you to manually
enter measurement values while conducting the tests. Click OK to
close the message.
