Docomo Foma SH905iTV, Instruction Manual

Page: 256 / 579

254
e11_dt20_7e.fm
[254/260]
i-
a
pp
li
If i-
a
ppli To (Run i-
a
ppli) is set, i-
a
ppli can be started from a
site, i-mode mail, Message R/F, screen memo or ToruCa.
i-
a
ppli can also be started when the i-
a
ppli start signal is received
in the following methods.
Ir exchange
When the FeliCa mark is held up to a scanning device
Bar code reader
Set whether to allow i-
a
ppli To in i-
a
ppli To settings (
n
P. 237).
If i-
a
ppli To is set to [No], i-
a
ppli does not function.
Cannot be activated as i- a ppli stand-by.
Full Browser is not available.
1
Select i-
a
ppli in a site, mail, Message R/F, screen
memo or ToruCa
/ t /
[Yes].
To cancel: Press
H
while [i-
a
ppli activating] appears
/
[Yes].
Press c to operate i- a ppli set as the stand-by display. The i- a ppli
stand-by settings are not disabled, and the i-
a
ppli stand-by is
restarted when the stand-by display reappears.
Set whether to transmit from the software set as the i-
a
ppli
stand-by, using Stand-by network set (
n
P. 255).
1
In the software list, select software
/ C /
[Stand-by display]
/
[Yes].
When the software using transmission is set, a screen asking
whether to allow transmission appears. Select [Yes] to allow
transmission. When [No] is selected, data is not transmitted and
information may not be received.
Disabling the i-
a
ppli stand-by settings
In the software list, select software set as stand-by
/ C /
[Stand-by display]
/
[Yes].
i-
a
ppli To
Running i-
a
ppli from sites or i-mode
mail
Starting i-
a
ppli from sites or i-mode mail
<i-
a
ppli To>
Note
When i-
a
ppli is ended, the original site, received message screen,
screen memo, ToruCa display screen or screen for watching 1Seg
reappears.
If there is no software corresponding to the Run i-
a
ppli setting, [No
requested software] appears.
Some software run from a site cannot be saved on the FOMA terminal.
Depending on the site, the specified i-
a
ppli software can be
downloaded or updated if it is not saved on the FOMA terminal or
if a newer version is available for the software saved on the FOMA
terminal.
Depending on the software settings, the software may start
automatically after downloading is complete. In such cases, the
software cannot be saved to the FOMA terminal immediately after
downloading. After ending the software, select whether to save the
software if available.
Network set (
n
P. 237) may be required while running i-
a
ppli software.
i-
a
ppli To from i-mode mail is a function only available from i-mode
mail delivered from an IP (Information Provider). Not available for
i-mode mail exchanged between FOMA terminals.
i-
a
ppli stand-by
Setting i-
a
ppli as the stand-by
display
Note
dt20_E.book 254 ページ ２００７年１２月２５日 火曜日 午後２時２２分