Docomo Foma SH905iTV, Instruction Manual

Page: 158 / 579

156
e08_dt20_7e.fm
[156/170]
Cam
era
By importing images continuously while moving the FOMA terminal
horizontally, a panoramic picture can be created automatically.
Panoramic pictures are saved in the size of 1280 (W) × 320 (H).
The image quality is set to [SUPER FINE], AF mode is set to
[Standard], these settings cannot be changed.
Shooting panoramic pictures is not available when in sub camera
shooting and the Cycloid position.
1
In the still picture shooting screen,
press
m
.
Press
m
again, and the normal still picture
shooting screen reappears.
2
Press
t
.
.
After the shoot start sound, panoramic
shooting starts. Move the FOMA terminal to
either direction of left or right within the
range for shooting a panoramic picture (do
not move back once moved to one
direction). Steady the position of the cross
mark which appears in the center at the start of shooting.
For the moving speed of the FOMA terminal, make sure that
q
appears as the moving speed indicator on the lower left of the screen.
When shooting is almost completed,
t
appears. Even after
t
appears, the combined image is updated by moving the FOMA
terminal. However, when
u
appears, further updating is not
available. Proceed to step 3.
1
Cross mark display
Appears in the center of the display
considering the position where the
shooting is started as an origin. Use
this display to check the gap from
the origin when moving the camera.
2
Moving speed display
Indicates the moving speed of
FOMA terminal.
3
Press
t
to end shooting.
When the shooting end tone sounds, the imported images are
combined, and the preview screen appears.
4
Press
t
.
Closing the FOMA terminal or pressing
H
while shooting in the
Continuous mode causes shooting to be interrupted and the
Camera mode to be ended. In addition, changing the position
causes shooting to be interrupted, and the still picture shooting
screen appears.
Shooting panoramic pictures
<Panorama>
Note
Panoramic picture
shooting screen
r
Too slow
q
Appropriate speed
s
Too fast
Note
While shooting a panoramic picture, zoom and brightness cannot
be adjusted.
If an incoming call is received or the alarm is activated while
shooting a panoramic picture, importing is canceled, and the
images being imported up to that point are discarded.
While shooting a panoramic picture, if no operations are made for
approximately 2 minutes, the Camera mode automatically ends
and the stand-by display reappears. The images imported up to
that point are discarded.
When
s
appears, the image quality may deteriorate. Especially
when shooting close subjects, be careful not to display
s
.
When shooting is continued even after
t
appears, the parts shot
at the beginning and ending may be discarded.
Panoramic picture
shooting screen
1
2
dt20_E.book 156 ページ ２００７年１２月２５日 火曜日 午後２時２２分