Docomo Foma SH905iTV, Instruction Manual

Page: 255 / 579

253
e11_dt20_7e.fm
[253/260]
i-
a
pp
li
Note
If Auto start cannot be started, the error is recorded in the Auto
start error history.
Automatic startup is not available in the following situations.
Handset is turned off i-
a
ppli is running
Other functions are activated Call is in progress
When Auto start and Alarm (Alarm/Schedule/Reception/
Recording) are set for the same time
i-
a
ppli Function lock is set
Mail-type i-
a
ppli is set to start automatically when the 2in1
mode is set to [B mode]
FOMA card is not inserted
FOMA card inserted is different from the one that was used
when the appli with Auto start was downloaded
The functions below operate with the following priority when the
same time is set.
Reset settings deletes the auto start error history and disables the
i-
a
ppli Auto start settings.
If transmission setting for software with Auto start settings is set to
[Always confirm], a transmission confirmation screen appears upon
startup. If no operations are performed for approximately 5 seconds,
software starts automatically as if [No] was selected in the
confirmation screen.
When two Auto start times for the same software are set within 9
minutes of each other, Auto start does not function. Set Auto start
time interval to 10 minutes or more. [Run error] appears in the
Auto start error history.
Priority (high
b
low)
Function Auto power OFF
b
Auto power ON
b
Alarm
b
i-
a
ppli Auto start
Related Operations
Set the software startup time with FOMA terminal
settings
1
In the Custom menu, select [i-
a
ppli]
/
[Auto start]
/
[Details set].
2
Select a number.
To save new: Select a slot with [--------------------]
/ t
.
To change the setting: Select a number to change
/ t /
[Update].
To delete the setting: Select a number to delete
/ t /
[Delete].
3
Select software
/ t
.
4
Set.
Š Select [Daily]
/
enter a time (24-hour format)
/ t
.
Š Select [Select day]
/
select the day
t
(repeatable)
/
C /
enter a time (24-hour format)
/ t
.
Š Select [Set date]
/
enter the date and time (24-hour
format)
/ t
.
Enable the Auto start setting for supported software
Perform the steps 1 to 3 of “Setting the software startup
time with FOMA terminal settings”
/
[Time interval].
To disable, delete the setting in “Setting software startup time
with FOMA terminal settings”.
This cannot be selected for software without Auto start
settings.
dt20_E.book 253 ページ ２００７年１２月２５日 火曜日 午後２時２２分