Docomo Foma SH905iTV, Instruction Manual

Page: 552 / 579

19
Manual for PC connection setting_DT20.fm
J
Writing host (APN) information onto
the FOMA terminal
To write the indicated host (APN) setting to the
FOMA terminal, click [FOMA
端末へ設定を書き込
む
] (Write settings onto FOMA terminal) on the
Host (APN) setting screen.
J
Creating dial-up settings
On the host (APN) settings screen, select an
added or edited host (APN) and click [
ダイヤル
アップ作成 ] (New dial-up). A screen confirming
the writing of the setting to the FOMA terminal
appears. Click [
はい
] (Yes). After the setting is
written to the host (APN), the [ パケット通信用ダ
イヤルアップの作成 ] (New dial-up for packet
transmission) screen appears.
Enter a connection name and click [
ユーザ
ID
・パ
スワードの設定 ] (Set user ID and password)
(Can be left blank to connect when using mopera
U or mopera).
For Windows XP and Windows 2000
Enter a [ ユーザ ID] (User ID) and [ パスワード ]
(Password), specify the users to whom rights are
granted and click [OK].
For Windows Vista
Enter a [
ユーザ
ID] (User ID) and [
パスワード
]
(Password), and click [OK].
If the IP and DNS information from your provider
are available, click [
詳細情報の設定
] (Advanced)
on the new dial-up for packet transmission
screen, enter the necessary information and click
[OK].
After entering the information, click [OK]
b
[OK]
b
[FOMA
端末へ設定を書き込む
] (Write settings
onto FOMA terminal), confirm that the old setting
is to be overwritten and then write the settings.
This section describes how to set up packet
transmission and 64K data communications
without using the FOMA PC Setup Software.
To make the settings, communication software for
entering AT commands are required. “Hyper
Terminal”, which is included as standard with
Windows, is used here.
The flow for setting up with use of AT commands is as
follows.
To use 64K data communications, there is no host
(APN) setting.
Windows Vista is not compatible with “Hyper
Terminal”. Use Windows Vista compatible software to
set up communications (follow the instructions for the
software).
Communication Settings
Without the FOMA PC Setup
Software
Setting Communications for Packet
Transmissions and 64K Data
Communications
Note
Install the FOMA Communication Setting File before
making settings for packet transmission and 64K
data communications (
n
P. 5).
AT commands are commands for controlling the
modem. The FOMA terminal is compliant with AT
commands and also supports some extended
commands, as well as some unique AT commands.
Making host (APN) settings is not necessary when
using mopera U or mopera, the DoCoMo Internet
connection service, since it is set as the default.
Set Notify caller ID as necessary (When using
mopera U or mopera, set [Send]). The default setting
is [Not send].
Set other settings as necessary. Use is possible with
the default settings.
Start up communication software that supports AT
commands (steps 2 to 5)
Set the Dial-up
Network
(
n
P. 22)
End communication software (
n
step 7 on P. 21)
Set the host
(APN)
(
n
steps 6 and
7 on P. 20)
Send/Not send
caller ID
(
n
P. 21)
Manual for PC connection setting_DT20.fm 19 ページ ２００７年１２月２５日 火曜日 午後３時４５分