Digital Projection HIGHlite 10000Dsx+, User Manual

Page: 14 / 96

E-14
Control Terminals
1. Introduction
1. USB Port (USB A)(Type A)
When working on “menu”, commercially available USB mouse
is connected and used. See page E-45.
2. REMOTE IN 1 (Mini Jack)
Wired remote control input. See Page E-20.
Ferrite core supplied should be fitted to the projector end of
the Remote cable.
3. REMOTE OUT (Mini Jack)
For Daisy-chaining multiple projectors and operating them with
the same remote control. To do so, connect to a second
projector’s IN terminal to relay the input at the IN terminal of
the first projector until all the projectors are connected.
When Remote Control Cable is connected to this port, ferrite
core, which attached to this equipment, is assembled to Re-
mote Control Cable (near side of this equipment).
4. LAN Port (RJ-45)
This port is typically used for UTP Ethernet/Fast Ethernet. Use
this connector to control the Projector on a LAN. See page E-
26.
Ferrite core supplied should be fitted to the projector end of
the Remote cable.
5. PC CARD Slot
Insert a PC card, commercially available flash memory card or
optional wireless LAN card here.
6. PC CONTROL IN (D-Sub 9 Pin)
Connect to the external equipment such as a PC or control
system.
See page E-89 for information about the pin assignment of
this connector.
7. PC CONTROL OUT (D-Sub 9 Pin)
This connector is for future extension.
8. EXT. I/O (Mini D-Sub 15 Pin)
It is used when controlling the Projector from the external de-
vice equipped with a parallel interface.
See Page E-89 for information about the functions and logic
table of the various pins.
9. REMOTE IN 2 (XLR connector)
Using an extension cable such as an audio cable, permits re-
mote control input.
See page E-89 for information about the pin assignment of
this connector.
9
8 7 6 5
2
1 4
3