Digital Projection HIGHlite 10000Dsx+, User Manual

Page: 58 / 96

E-58
(4) Perform blending correction for the Right hand edge of the Left
projector.
Use
E
to adjust the blend of the left projector and press ENTER.
•
To change the number of pixels in the superimposed area, input the
same value as used in (3) above using the Remote Control numeric
buttons, then press ENTER.
This value can also be adjusted using
F
or
E
, on the remote control.
- Adjusting the lens shift
Fine position adjustment of the images projected is allowed. This
adjustment is saved as Ref. Adjust data.
1. On the [Edge blending] - [Page 1] screen, select “Lens Shift”.
- [Lens Shift] screen appears.
2. Using the SELECT button on the remote control, adjust the
positions of the projected images.
- Set the adjustment value to a minimum. A larger value may warp
images, and the superimposed area may not be correctly adjusted.
3. After the lens shift adjustment is completed, press the CANCEL
button.
- The screen goes back to [Edge Blending] - [Page 1] screen.
- Adjusting the black level
If two projectors are used for projection, the superimposed areas can
appear brighter with no input signal.
Adjust the black level of the non-superimposed area to be as bright
as the superimposed area, so that even with no signal input, the
brightness of the whole screen is the same.
This adjustment is saved as reference setting data in the projector.
(1) Select “Black Level” in the [Edge Blending] - [Page 1] screen.
Image disappears, and the adjustment bar is displayed.
(2) Adjust the screen brightness evenly using the
G H F E
buttons on
the remote controller.
G H
buttons: Increases/Decreases the correction value in steps of
10.
F E
buttons: Increases/Decreases the correction value in steps of 1.
Adjust the brightness of the dark part (non-superimposed area) and
that of the bright area (superimposed area) so that the whole screen
brightness is even. Before this adjustment, perform (1) for each
projector.
To perform edge blending when two or more projectors are used,
adjust the brightness in the same way so that the brightest
superimposed area is as bright as the non-superimposd area.
(3) Press the ENTER button when the adjustment of black level has
been completed.
[Edge Blending] - [Page 1] screen reappears.
- Setting the “Keep Marker” check box
Check this box to display the marker even after the [Edge Blending]
screen is exited.
1. On the [Edge Blending] - [Page 1] screen, check the “Keep Marker”
check box, and press the ENTER button.
- The check box is checked.
- The marker is displayed even after the [Edge Blending] screen is
exited.
- If the projector is placed on standby, the check box is automatically
unchecked.
- Adjusting the image output range and position
Adjust the output range and position of images projected by each
projector when two projectors are used to display one combined-
image. Connect the desired video signals to two projectors, and
adjust the following while projecting the images. This adjustment is
possible per signal.
(1) In “Input Resolution” on the [Edge Blending] - [Page 2] screen, adjust
the area for each projector to display.
In the example, two projectors display the left and right half
respectively. Enlarge each half using the horizontal adjustment bar.
(2) In [Input Resolution] on the [Edge Blending] - [Page 2] screen, adjust
the output position of images to be enlarged through each projector.
6. Using On-Screen Menu