Digital Projection HIGHlite 10000Dsx+, User Manual

Page: 24 / 96

E-24
AUDIO OUT
L R
Component
COMPONENT
Y Cb Cr
3
Making Connections
Connecting to the Image Input Terminals
This Projector has two interface boards, MM-VIDEO and MM-RGB as standard equipment. See page E-11. Connect required video
signals.
Four interface boards can be inserted in the Projector at the same time. See Page E-25.
Component video RCA
⳯
3 cable
(not supplied)
RCA(female)-to-BNC(male)
adapter (not supplied)
2. Installation
BNC
⳯
5 cable
(not supplied)
HIGHlite 1
PC DVD player
Information for Reducing Radiation of Electromagnetic
Waves
To reduce unnecessary radiation of electromagnetic waves, use
the supplied ferrite clamp core.
• When cable is for RGB signal, ferrite core is assembled to the
both side of the cable.
• When cable is for DVI-D signal, ferrite core is assembled to
the side where ferrite core is not attached.
Installation Instructions
1. Opne the attach the ferrite clamp core to the cable as close as possible
to end that goes to the Projector.
* Push the catch to open the ferrite clamp core.
* Loop the cable once around the ferrite clamp core.
NOTE: When cable is thick, ferrite core is assembled without making a ring.
2. Close the ferrite clamp core tightly.
3. Fix the supplied band to the Ethernet cable as a stopper.
* Pull the end of the band to tighten it. Cut off the surplus of the band.
band
Ferrite clamp core (supplied)