Digital Projection HIGHlite 10000Dsx+, User Manual

Page: 42 / 96

E-42
5. Setting Up for Double Stacking in Link Mode
2
Adjusting and Registering Signals to Be
Projected
2
-1. Making Adjustments to the Master Projector
2
-1-1. Display a desired input signal on the master projector.
2
-1-2. Make adjustment to the signal, then save (register) ad-
justments on the master projector by pressing and holding
CTL and pressing ENTRY LIST button on the remote con-
trol.
2
-1-3. Repeat steps
2
-1-1 and
2
-1-2 for all signals you want
to project.
Display all the signals you registered and check. To check,
select “Source Select”
→
“Entry List”.
2
-2. Making Adjustments to the Slave Projector
2
-2-1. Display a desired input signal on the slave projector.
2
-2-2. Make adjustment to the signal, then save (register) ad-
justments on the slave projector by pressing and holding
CTL and pressing ENTRY LIST button on the remote con-
trol.
2
-2-3. Repeat steps
2
-1-2 and
2
-1-2 for all signals you want
to project.
Display all the signals you registered and check. To check,
select “Source Select”
→
“Entry List”.
3
Adjusting the Lens Shift, Zoom and Fo-
cus to Clearly Display all projected patterns
3
-1. Display the internal crosshatch test pattern.
NOTE: Use a different single colour for each projector. Example: Turn on Green of
master projctor, then Red of the slave projector.
3
-2. Adjust the Lens Shift by pressing and holding CTL and press-
ing the POSITION button on the remote control.
For lens shift adjustable range, see page E-23. Lens Shift Ad-
justable Range.
3
-3. Zoom the lens in and out by pressing and holding CTL and
pressing the MAGNIFY(ZOOM)+/- button on the remote con-
trol.
3
-4. Adjust the lens focus by pressing and holding CTL and press-
ing the FOCUS +/- button on the remote control.
NOTE: If the physical (vertical) alignment of the projector is not correct, adjust the
height of the feet. If there is any keystone distortion, use 3D-Reform (Keystone)
adjustment to correct and save the settings on each projector. See page E-55 for
3D-Reform.