Digital Equipment RW504-ZA, Service Manual

Page: 190 / 220

Table A–3 (Cont.) Autochanger Micro-Move Error Codes
Error
Code
(hex)
Description
25 Failed to see height sensor re-open after closing at the start of a translate.
28 The translate distance was too long.
29 The translate distance was too short.
31 Failed while checking for cartridge in a drive.
32 Failed to find a hard stop returning cartridge to storage after testing for presence
of cartridge.
33 Failed while checking for cartridge in a storage slot.
34 Failed while checking for cartridge in the Picker.
35 Failed while checking for cartridge in the mailslot.
36 Could not free fingers after testing for a cartridge in a drive.
38 Failed to verify that cartridge exists after insert.
40 Failed finding the back of storage slot during retraction.
41 Failed to verify that a disk is in the storage slot on get using cartridge-in-path
beams.
42 Not able to measure the depth of the storage slot.
43 Failed to free fingers from the storage slot.
48 Could not find the back of the storage slot after insert.
49 Failed to verify that a cartridge exists in the storage slot after insert.
4A Could not free fingers from storage slot after insert.
50 Could not find the back of the mailslot after get.
51 Failed to verify that a disk is in the mailslot on get using cartridge-in-path
beams.
52 Not able to measure the depth of the mailslot.
58 Could not find the back of the mailslot after insert.
59 Failed to verify that a cartridge exists in the mailslot after insert.
60 Failed to rotate the mailslot in.
61 Failed to rotate the mailslot out.
70 Exhausted retries while attempting to get the drive to eject the cartridge.
(continued on next page)
A–12 Offline Diagnostic Information