Digital Equipment RW504-ZA, Service Manual

Page: 49 / 220

3.3.4 Setting the SCSI Address
Note
Determine what SCSI device addresses are currently in use on the host
system. You can then correctly determine what available SCSI addresses
to use for the optical drive mechanism and the autochanger controller.
The default address settings are as follows:
• Autochanger controller - SCSI ID 3
• Optical drive mechanism - SCSI ID 4
If you want to change either address, follow these steps.
Note
Pressing
CANCEL
at any time will return you to the
READY
state or will
take you back one step each time it is pressed.
1. With
READY
displayed, press
NEXT
until
SCSI ID *
displays.
2. Press
ENTER
. AC ID 3 displays.
This is the autochanger controller address. If you want to change this
address, press
ENTER
, otherwise press
NEXT
to display DRV ID 4 and then
press
ENTER
.
3. Press
NEXT
or
PREV
until the address you want is displayed.
4. Press
ENTER
. The address you chose is now set.
5. Press
NEXT
until either
UPDATE
or
CONFLICT
displays.
If
CONFLICT
displays, the drive and controller have been set to the same
address and one of them must be reset.
If
UPDATE
displays and you are satisfied with the addresses you have selected,
press
ENTER
]].
6. Record the new address setting(s) for future reference.
Product Operation and Configuration 3–7