6–8
Solving Problems
If you want to test a consecutive series of devices, enter TEST followed
by the first and last numbers of the series:
>>>
TEST F 7
Return
>>>
The system displays the number of each device as it is tested, followed
by a series of periods.
If the self-test is successful,
no question mark or error message is
displayed, and the console prompt appears:
7...
>>>
If a device fails the self-test,
a failure message is displayed before
the console prompt appears.
7?..
84 FAIL
>>>
If a self-test results in a failure, run the configuration display to show
any error codes.
Configuration Display
This procedure displays the system configuration, Ethernet ID, ROM
revision levels, and status information for your InfoServer 100. Error
information in this display is valuable to your service representative.
Have this information ready if you must call for service. See Chapter 4
and Appendix A for additional information. Table 6–3 lists the mnemonic
code used for each device. To display your system configuration, perform
the following steps:
NOTE
The halt button halts the system.
1. Put the system in console mode by pressing the halt button on the
rear of the system unit.
2. Enter the TEST 50 command at the console prompt. The following
example shows a sample display. Table 6–3 lists the mnemonic code
used for each device.
