Expanding Your System
4–5
Connecting One Expansion Box
To connect a single expansion box to your system unit:
1. Set the
l O
power switches on the system unit and expansion box to
the off (O) position.
2. Turn the expansion box so that the back is facing you.
3. Verify the SCSI ID switch positions, as described in Appendix A.
Each device is shipped with the SCSI ID switches in the default
switch position. Set the switches to the desired SCSI ID number
by reading the switch positions from left to right. Refer to the
information provided with the expansion box to determine how the
switches are set.
4. Connect the 50-pin to 50-pin expansion box cable as follows:
Connect one end of the cable to the SCSI port on the rear of the
system unit. Snap the bail lock loops in place.
Connect the other end of the cable to the top port on the rear of the
expansion box. Snap the bail lock loops in place.
5. Connect a 50-pin terminator to the lower port on the expansion box.
MLO-002346
CAUTION
Check the voltage requirement of the expansion box before
powering up.
6. Connect the power cord to the power receptacle on the expansion box,
then plug the other end into a grounded power outlet.
