2–10
Installing Your System
Connect a Console Terminal
You do not need a locally connected terminal for normal InfoServer
operation. However, Digital advises that you connect a local terminal
as part of this installation procedure, to ensure that the InfoServer is
operating properly.
The recommended console terminal is a VT300 series terminal. When
you connect the terminal cable to one of the MMJ ports on the rear of the
VT300 series terminal, the port must be set for DEC-423 operation. See
your terminal documentation for details.
To connect a terminal to the server:
NOTE
Make sure the
l O
power switch on the terminal is off (O).
1. Connect the terminal cable supplied with the system to MMJ port 1
on the rear panel of the system unit.
Local Terminal
Cable
MLO-002750
M A - 0 3 6 0 - 9 0 . D G
2. Connect the other end of the console cable to the communications port
on the terminal.
3. The terminal must be set at 9600 baud, with 8 bits, and no parity.
See your terminal documentation if you need information on setting
up your terminal.
