HARDWARE AND WIRING
3.7.15
AGS2 TRANS TEMP LAMP
The AGS2 Trans Temp Lamp is controlled by DDEC VI..
The AGS2 Trans Temp Lamp remains ON:
□
For approximately
fi
ve (5) seconds at the start of every ignition cycle
(a bulb check)
□
When transmission temp is high
AGS2 Trans Temp Lamp Requirements and Guidelines
The following requirements and guidelines apply to the AGS2 Trans Temp Lamp:
□
The AGS2 Trans Temp Lamp is optional.
□
A 12 volt light of less than 0.25 A (DC) is required depending on the ignition source.
Digital output circuits are designed to sink no more than 0.25 A (DC) current.
□
The AGS2 Trans Temp Lamp must be integrated into the instrument panel or placed in
clear view of the vehicle operator.
□
This output is wired to pin 3/10 of the CPC.
Programming Requirements and Flexibility
The options for this digital output are listed in Table 3-121.
Parameter
Group
Parameter
Setting
Options
Default
Access
35
3 10 DO
Selection
2 = AGS2
Check
Transmis-
sion Indica-
tion Lamp
0 = Disabled
1 = Air Filter Lamp*
2 = AGS2 Transmission Temp Indication
Lamp
3 = Battery Voltage Low Lamp
4 = Coolant Level Low Lamp
5 = FUSO Retarder Control 1*
0 =
Disabled
VEPS or
DRS
35
3 10
DO Fault
Detection
–
0 = Disabled
1 = Enabled
0 =
Disabled
VEPS or
DRS
* Not supported in NAFTA
Table 3-121
AGS2 Trans Temp Lamp Programming Options
3-122
All information subject to change without notice.
(Rev. 01/07)
7SA827 0701
Copyright © 2007 DETROIT DIESEL CORPORATION
